Sporadically, for the last 2 weeks, I’ve had my watercooling loop equipment arriving by mail, from various areas. My vendors didn’t have a few parts I needed, so I ordered them from the manufacturer… in Slovenia.
Anyways, it’s starting to show up now, and here’s some beauty shots:
10 feet of norprene 1/2″ outer diameter/ 3/8″ inner diameter tubing with 4 lengths of anti-kink coil
10x G 1/4″ EKWB 1/2″ OD/3/8″ ID compression fittings
4x G 1/4″ EKWB 1/2″ OD/3/8″ ID 45 degree angle adapter
2 liters of EKWB UV reactant, corrosion resistant, green, premixed coolant with biocide (1 is still on back order)
1x 1″ tubing cutting tool
1x EKWB full coverage waterblock for the GTX 780ti, and a backplate for good measure
1x EKWB full coverage waterblock for the Asus Maximus VI Impact – The board’s so small that they just lengthened the sides of the CPU block to cover the VRM daughterboard on one side and the PCH on the other, then voila! Full coverage!
1x Custom reservoir, built to this case’s specifications
And 1x EK-DCP 2.2 (12V DC Pump).
Unfortunately, the 240mm radiator and 90 degree adapter fittings were on backorder, so I’ll have to wait for at least the rad to get the project under way. Can’t wait though! My first custom loop, going to be so much fun. And quite the challenge in this case.
Potentia 